Kärcher NT 35/1 Tact Notice Originale page 13

7 Air inlet, motor cooling air
8 Dirt receptacle
9 Steering roller
10 Suction head
11 Suction support
12 Floor nozzle
13 Suction pipe
14 Carrying handle
15 Filter cover
16 Bender
17 Rotary switch for suction output (min-
max)
18 Indicator lamp
19 Socket
20 Automatic filter dedusting
21 Main switch
22 Flat fold filter
23 Filter dedusting
24 Floor nozzle holder
25 Holder for floor nozzle
26 Holder for suction pipes
27 Power cord
28 Nameplate
Start up
Anti-static system
Tact Te only:
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.
Dry vacuum cleaning
Caution
The flat pleated filter must must always be
in place while vacuuming.
When vacuuming fine dust, you may
–
also use an additional paper filter bag or
a membrane filter (special accessory).
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag or the mem-
brane filter (special attachment).
 Insert and lock the suction head.
Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
If the appliance is used to vacuum wet
–
dirt the paper filter bag or the mem-
brane filter (special accessory) must al-
ways be removed.
It is recommended to use a special filter
–
bag (wet) (see Filter systems).
General
Caution
The flat pleated filter must must always be
in place while vacuuming.
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After having completed the wet vacuum
–
operation clean the flat pleated filter,
the electrodes and the container and let
dry.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
2
-
EN 13