Publicité
Les langues disponibles
Les langues disponibles
GESF 260
Defects searching
Symptom
Possible cause
Engine not starting
Feeder cable is not connected or is faulty
House wiring fuse is overloaded
Wrong switch/plug combination
Engine mum-
blower worm or eject channel is blocked. Unplug the appliance, remove the blo-
bling but not running
Abnor-
Screws, nuts or other tightening compon-
ents are loose.
mal sound (grum-
bling, rattling, clatter)
Shaking, vibrations
Loose components or the blower worm
is damaged.
Appliance not remo-
blower worm or eject channel is blocked. Stop the engine. Unplug the appli-
ving snow
V-belt is loose or broken.
Removal
Check the cable, plug it or replace it
or have it repaired by a professional
if necessary.
Switch the fuse on or use a house con-
nection with higher protection or have it
installed by a professional.
Have it repaired by an authorised shop.
cking, wait for app. 10 minutes and start
the appliance again.
Tighten the components. If the abnor-
mal sound persists, contact immediately
an authorised shop.
Stop the engine. Unplug the appliance.
Have the damaged blower worm re-
paired. Tighten any loose screws and
nuts.
ance. Remove the blocking.
Have the V-belt checked in an authori-
sed shop.
ENGLISH
15
Publicité
