GEZE Slimdrive SD Notice De Montage page 15

Integrierte Schließfolgeregelung Slimdrive SD Türblattmontage Bandseite , Datei 88340 SD_IS-T-BS_180400.p65
Mounting of cable at the guide rail
Illustration for active leaf right
(for the left side correspondingly)
Insert end of cable from the direction of the hinge into the end
piece of the short guide rail.
Insert casing of Bowden cable and push through the lead-in
up to the adjusting device of the Bowden cable.
Pull end of rope up to the diversion of the long rail, lead
through the clamping screw and only slightly tighten the cable
without stretching it.
Watch out for the correct seat of the Bowden cable
casing at the ends (seat in the recesses)!
Move door leaf for trial. The Bowden cable must not be
stretched or jammed.
If necessary:
To lengthen or shorten the loop, the adjusting device of the
Bowden cable can be displaced within the row of holes of the
rail.
To do so, loosen cable clamping, lift strap of the adjusting
device, dislocate and allow to snap in again.
Clamp cable again.
Adjusting device of
Bowden cable
End piece
Casing
15