Storage; Care And Service - Tornado CVD 30/1 Mode D'emploi

Storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
storage.
The device may only be operated indoors.

Care and service

Maintenance intervals
ATTENTION
Risk of damage
Please adhere to the specified mainte-
nance intervals in order to prevent damage
to the device.
Daily
1. Clean the roller brush.
Weekly
1. Check the roller brush for wear.
Note
The degree of wear can be determined by
comparing the differently coloured indicator
tufts. Replace the roller brush when the
black bristles are the same height as the
red bristles.
Cleaning the roller brush
1. Remove the brush cover if necessary:
Use a coin to turn the rotary lock by 90°
and remove the brush cover.
2. Cut off hair and threads wound onto the
roller brush using scissors and remove
them.
Changing the filter bag
1. Unlock and remove the filter cover.
2. Turn the filter bag lock to the right to un-
lock. Close the filter bag, remove and
dispose of it.
10
3. Insert a new filter bag and turn the filter
bag lock to the left to lock.
4. Fit and lock the filter cover.
Replacing the exhaust filter
1. Unlock and remove the filter cover.
2. Push the filter casing locking mecha-
nism upwards and remove the filter cas-
ing.
3. Remove the exhaust filter from the filter
casing.
4. Insert a new exhaust filter in the filter
casing.
5. Insert the filter casing and latch it into
place.
6. Fit and lock the filter cover.
Replacing the motor protection filter
1. Unlock and remove the filter cover.
2. Press the motor protection filter lock up-
wards. Remove the old motor protection
filter and dispose of it.
3. Fit and lock the new motor protection fil-
ter.
4. Fit and lock the filter cover.
Replacing the roller brush
Please make sure that the bracket is al-
ways completely opened during installa-
tion.
English