Unpacking; Attachment / Before Starting The Equipment - Scheppach HWW900 Traduction Des Instructions D'origine

7. Unpacking

Open the packaging and remove the device carefully.
Remove the packaging material as well as the packaging and transport bracing (if avail-
able). Check that the delivery is complete.
Check the device and accessory parts for transport damage. In case of complaints the
dealer must be informed immediately. Subsequent complaints will not be accepted.
If possible, store the packaging until the warranty period has expired. Read the operating
manual to make yourself familiar with the device prior to using it.
Only use original parts for accessories as well as for wearing and spare parts. Spare parts
are available from your specialized dealer. Specify our part numbers as well as the type and
year of construction of the device in your orders.
m ATTENTION
The device and packaging materials are not toys! Children must not be allowed
to play with plastic bags, film and small parts! There is a risk of swallowing and
suffocation!

8. Attachment / Before starting the equipment

Installation of a suction line
• Screw a suction hose (plastic hose min. 19 mm (3/4") directly or with a threaded nipple,
approx. 25.4 mm (1"), to the suction line connection on the pump.
• Lay the suction line from the water pick-up point to the pump in a continuously rising
slope. Ensure that the suction line is not laid above the pump height; air bubbles in the
suction line delay and prevent the suction process.
• The suction and pressure lines must be installed in such a way that they do not exert any
mechanical pressure on the pump.
• The suction valve should be located deep enough in the water to prevent the pump from
running dry if the water level drops.
• A leaking suction line will prevent the water from being sucked in due to air ingress.
• Avoid sucking in foreign bodies (sand etc.).
Installation of a pressure line
• The pressure line (should be at least 19 mm (3/4")) must be connected directly or via a
threaded nipple approx. 25.4 mm (1") to the pressure line connection on the pump.
• During the suction process the shut-off devices (spray nozzles, valves etc.) in the deliv-
ery line must be fully opened to allow the air in the suction line to escape freely.
26 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58