Scheppach HWW900 Traduction Des Instructions D'origine page 24

• If the connection cable of this unit is damaged, it must be replaced by the manufacturer
or their service department or a similar qualified person in order to avoid hazards. The
voltage of 230 volts AC indicated on the type plate of the pump must correspond to the
mains voltage present.
• Never lift, transport or fasten the pump by the mains cable.
• Make sure that the electrical plug connections are located in a flood-proof area or are
protected against moisture.
• Before any work on the pump, pull out the mains plug.
• Ensure that the pump is not exposed to a direct water jet.
• The operator is responsible for compliance with local safety and installation regulations
(ask a qualified electrician if necessary).
• The user must implement suitable measures (e.g. installation of an alarm system, re-
serve pump or similar) to prevent consequential damage caused by flooding of rooms in
the event of pump faults.
• If the pump fails, repair work may only be carried out by a qualified electrician or by cus-
tomer service.
• Only use original spare parts.
• The pump must never be allowed to run dry or be operated with a fully closed suction
line. Damage to the pump caused by dry running will invalidate the manufacturer's war-
ranty.
• The pump must not be used for swimming pool operation.
• The pump must not be installed in the drinking water circuit.
Remaining hazards
The machine has been built using modern technology in accordance with recog-
nized safety rules. Some remaining hazards, however, may still exist.
• Injury through electric current if incorrect electric connection leads are used.
• Even when all safety measures are taken, some remaining hazards which are not yet
evident may still be present.
• Remaining hazards can be minimized by following the safety instructions as well as the
instructions in the chapter Authorized use and in the entire operating manual.
• Health hazard due to electrical power, with the use of improper electrical connection
cables.
• Release the handle button and switch off the machine prior to any operations.
• Avoid accidental starts of the machine: Do not press the start button while inserting the
plug into the socket.
• Use the tools recommended in this manual to obtain the best results from your machine.
• Always keep hands away from the work area when the machine is running.
24 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58