Disposal And Recycling; Troubleshooting - Parkside PBTS 370 A1 Consignes D'utilisation Et De Sécurité

Please provide the following information in the event of any
enquiries:
• Type of current for the motor
• Data of machine type plate
• Data of motor type plate

15. Disposal and recycling

The device is supplied in packaging to avoid transport dam-
ages. This packaging is raw material and can thus be used
again or can be reintegrated into the raw material cycle.
The device and its accessories are made of different materi-
als, such as metals and plastics. Take defective components to
special waste disposal sites. Check with your specialist dealer
or municipal administration!

16. Troubleshooting

Fault Possible cause
Motor does not start On/off switch damaged
On/off cable damaged
On/off relay damaged
Machine becomes Too much pressure is applied to the workpiece.
slower during work.
Sanding belt comes off It does not run straight.
the drive pulleys.
Wood gets burnt during Sanding disc or belt is covered with grease.
sanding.
Excessive pressure was applied to the
workpiece.
20 GB/IE
The packaging is wholly composed of environ-
mentally-friendly materials that can be disposed
of at a local recycling centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
Old devices must not be disposed of with household
waste!
This symbol indicates that this product must not be dis-
posed of together with domestic waste in compliance
with the Directive (2012/19/EU) pertaining to waste
electrical and electronic equipment (WEEE). This prod-
uct must be handed over at the intended collection point. This
can be done, for example, by returning it when purchasing a
similar product or delivering it to an authorised collection
point for the recycling of old electrical and electronic devices.
Improper handling of waste equipment may have negative
consequences for the environment and human health due to
potentially hazardous substances that are often contained in
electrical and electronic equipment. By properly disposing of
this product, you are also contributing to the effective use of
natural resources. You can obtain information on collection
points for waste equipment from your municipal administra-
tion, public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equipment or
your waste disposal company.
Remedy
Replace all damaged parts before you use your
sander again.
Contact your local service centre or an authorised
service station. Every attempt to carry out a repair, can
be dangerous if it is not done by skilled personnel.
Apply less pressure to the workpiece.
Reset the track.
Replace belt or disc.
Reduce the pressure applied to the workpiece.