Publicité
Les langues disponibles
Les langues disponibles
EN
5. Using a socket wrench, remove the large pulley (29).
6. Remove the screws (24) that secure the left side plate.
7. Pull the axle (30) and remove the old impeller, install the
new impeller.
8. Reinstall the nut (27) and right side cover.
9. Reinstall the left side plate (32), large pulley (29), belt
(28) and left side cover (31).
32
29
24
30
27
27
28
31
26
24
English
8.4
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
9
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
The motor is on,
but the impeller
does not turn.
A thin layer of
snow stays behind.
* If you cannot find the solution to these problems, please go
to the service center.
10
TECHNICAL DATA
Voltage
No load speed
Working width
Clearing depth
Weight
12
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The switch is de-
Have the switch
fective.
replaced by an au-
thorized service
center.
The extension
Connect the plug
cord is not connec-
on the machine to
ted to the plug.
the extension cord.
The extension
Plug the extension
cord is not connec-
cord into a live
ted to the power
120 V AC, 60 Hz
source.
outlet.
The belt is dam-
Replace the belt.
aged.
The scraper is
Replace the scra-
damaged.
per.
120 V, 60 Hz, 13 A
2500 RPM
20 in. (50.8 cm)
10 in. (25.4 cm)
32.4 lbs (14.7 kg)
Double-insulated
construction
Publicité
