GreenWorks 2606502 Manuel D'opérateur page 10

3. Align the arrows in the discharge chute and snow thrower
deck. Make sure the discharge chute faces forward.
4. Put the end of the chute control rod (2) straight through
the hole (18) in the bracket. Keep the grip handle down.
5. Push the chute control rod (2) into the hole (18) behind
the deck.
6. Turn the grip handle left and right to make sure that the
discharge chute moves in the same direction.
7 OPERATION
WARNING
Wear eye protection during operation.
7.1 START THE MACHINE
1
14
1. While holding the safety switch button (14), pull the bail
lever (1) to start the machine.
NOTE
Lower the scraper to the ground to remove the snow.
WARNING
Keep bystanders a safe distance from the machine.
WARNING
Examine the work area. Remove all stones, sticks, wire,
bones, and other debris that can ricochet because of the
rotating impeller.
English
7.2 STOP THE MACHINE
1
1. Release the bail lever (1) to stop the machine.
Wait until the impeller fully stops before you start the
machine again. Do not quickly turn the machine off and on.
Pull the plug after you complete the work.
7.3 USE THE CORD RETAINER
13
Do not plug the extension cable into the outlet until it has
been connected to the cord retainer and plugged into the
machine.
1. Fold the extension cable to form a tight loop near the
retainer (13).
2. Push the loop through the bottom hole in the retainer
(13).
3. Move the loop over the retaining clip, and pull until the
cable is secured.
9
WARNING
WARNING
NOTE
EN