Troubleshooting - GreenWorks 25022 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
Handle not in
position.
Mower not starting. Extension cord not connected to Reconnect the cord and use the cord
Mower cutting
unevenly.
Mower not mulching Wet grass clipping s sticking to
properly.
Mower hard to push. High grass, rear of mower
Mower vibrating at
higher speed.
POSSIBLE CAUSE
Carriage bolts not seated
properly.
Handle knobs not tightened.
the mower plug.
Extension cord not connected
to power source.
Motor control switch defective.
Lawn is rough or uneven or
height not set properly.
the underside of the deck.
housing and blade dragging in
heavy grass, or cutting height
too low.
Blade is unbalanced.
Bent motor shaft.
SOLUTION
Adjust the height of the handle and make
sure the carriage bolts are seated properly
Tighten handle knobs.
retainer to keep the cord close to the
motor/blade control.
Connect the extension cord to a live
120V AC, 60 HZ AC receptacle.
Have motor control switch replaced
by an authorized service center.
Move the wheels to a higher position.
All wheelsmust be placed in the same
cutting height for the mower to cut evenly.
Wait until the grass dries before mowing.
Raise cutting height.
Balance the blade by grinding each
cutting edge equally.
Stop the motor, disconne ct the power
source, and inspect for dam age. Have
repaired by an authorized service center
before restarting.
26