Publicité
Les langues disponibles
Les langues disponibles
Dyna-Glo Delux Operating Instructions and Parts Manual
Model R 125DGD
Maintenance (Continued)
2. Inspect heater before each use. Check
connections for leaks. pply a 50/50
solution of dish soap and water.
Bubbles forming show a leak that
must be corrected. Correct leaks at
once.
3. Inspect regular hose assembly before
each use. If hose is highly worn or
cut, replace with hose specified by
manufacturer.
4. Keep appliance area clear and free
from combustible materials, gasoline,
and other flammable vapors and
liquids.
Troubleshooting Chart
Symptom
Burner fails to light
Burner lights but goes out
when automatic control
valve button is released
Burn rate is low, emitter
does not glow
Flames are extremely low
and coming from emitter
For Technical Support or Troubleshooting, Call: 1-877-477-4768, 8:00 am - 5:00 pm CST
5. Have heater inspected yearly by a
qualified service person.
6. Installation must conform with local
codes or, in the absence of local
codes, with the Standard for the
Storage and Handling of Liquefied
Petroleum Gases, NSI/NFP 58 and
the Natural Gas and Propane
Installation Code, CS B149.1.
STOR GE
supply.
1. The heater is to be stored indoors.
The connection between the propane
supply cylinder(s) and the heater must
Possible Cause(s)
1. More warm-up time needed
2. Gas pressure is low
3. Thermocouple loose or in need of replacement
4.
utomatic control valve in need of replacement
1. Main burner valve not completely open
2. Clogged gas orifice
3. Low gas pressure
4. Low gas supply
1. Main burner valve not fully open
2. Plugged gas orifices
3. Low gas pressure
4. Low fuel supply
Unit has been connected to a natural gas supply
instead of propane gas
be disconnected and the cylinders
removed from the heater and stored
in accordance with Standard for the
Storage and Handling of Liquefied
Petroleum Gases, NSI/NFP 58 and
CS B149.1, Natural Gas and Propane
Installation Code.
2. Place plastic cover over brass fitting
on inlet connector.
3. Store in a dry, clean, safe place.
Disconnect heater
4. When taking the heater out of
from propane gas
storage, always check inside the
heater. Small animals or insects may
place foreign objects in the heater.
Keep heater free from foreign objects
and combustible materials.
Corrective
1. Relight, holding control valve button
in for 45 seconds
2. Inspect propane gas supply
3. Tighten, reconnect or replace
thermocouple
4. Replace automatic control valve
1. Completely open main burner valve
by turning control knob to HIGH
position
2. Replace gas orifice
3. Check gas supply, regulator function
4. Consult gas supplier or replace tank
1. Fully open main burner valve by
turning control knob towards HIGH
position until it stops
2. Replace gas orifice
3. Check gas supply, regulator output
4. Consult gas supplier or replace tank
Check gas source and replace with
propane gas supply
5
ction
www.ghpgroupinc.com
PROFESSIONAL GRADE
E
N
G
L
I
S
H
Publicité
