JB Systems MB ROTATOR HEAVY DUTY Mode D'emploi page 5

ENGLISH
INSTALLATION INSTRUCTIONS
1. The fixation holes are located on the base plate.
2. Hold the base plate onto the location where the device is to be installed.
3. Mark the boreholes with a pen or a suitable tool.
4. Drill the holes.
5. Hold the base plate in the desired position and tighten it.
6. Attach the mirror ball using the mirror ball chain
7. If the mirror ball has a second safety eyelet, also use a safety chain to secure the mirror ball.
If the mirror ball does not have a second safety eyelet, you don't have to use 2
OPERATING INSTRUCTIONS
 Once connected to the mains the device starts running.
 Regular breaks during operation are essential to maximize the life of this device as it is not designed for
continual use.
 Always unplug the unit when it is not used for a longer time or before servicing.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Unplug the mains cable .
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
SPECIFICATIONS
Mains Input:
Cable connections:
Power consumption:
Maximum load:
Rotation Speed:
Size:
Weight:
JB SYSTEMS®
Every information is subject to change without prior notice
AC 230V, 50Hz
Brown = L(Live) * Blue = N(Neutral) * Yellow/Green = Earth
3,5W
10kg (chains + Mirror ball)
1RPM
19 x 19 x 13cm
1kg
3/18
OPERATION MANUAL
nd
the safety chain.
MIRROR BALL MOTOR