Federal Communication Commission (FCC) Notice
This equipment has been tested and found to comply with the limits of a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that the
interference will not occur in particular installations. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from what the receiver is
connected
•
Consult an experienced radio TV technician for help.
CAUTIONS:
The change or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Shielded interface cables and AC power adapter, if any, must be used in order to comply with the
emission limits.
Page 2
FCC Notice
© LINDY ELECTRONICS LTD