Brizo MultiChoice T60P Serie Instructions D'installation page 6

T60P Series Installation
Showerhead and Tub Spout Installation
2
(For Tub Spout installation refer to the installation guide provided with your tub spout)
FOR SHOWERHEAD INSTALLATION:
Connect top outlet (1) to shower arm (2) with
proper fittings. To prevent damage to finish on
shower arm, insert wall end of shower arm into
shower flange (3) before screwing arm into
riser connection. Thread showerhead (4) onto
shower arm. Apply plumber tape to pipe threads
on both ends. Do not overtighten showerhead.
1
3
2
4
3
FOR RSVP (RP48040), SOTRIA
®
(RP75722) AND VIRAGE
SHOWER ARM INSTALLATION:
Install a 1/2" threaded pipe nipple to extend beyond
the finished wall 3/8" to 1/2". Apply plumber tape to
thread on pipe nipple and screw brass adapter (1)
securely onto nipple. Apply plumber tape to outlet
end of shower arm and screw showerhead (2) onto
the shower arm (3), using provided wrench (4) to
tighten securely. Check position of set screw on top
of shower arm (3) making sure it is not sticking
through to the inside opening where it could
interfere with the assembly. Slide shower arm and
head assembly over the adapter and tighten set
screw against the adapter.
4
1
4
2
®
(RP62603)
®
92782 Rev. A