Setup And Operation - Greenlee Gator LS50L2 Manuel D'instructions

Setup and Operation

Punching
Note: The LS50L2 is equipped with a microprocessor
to control the operation. It automatically shuts off if
punching does not begin within 1 second after pulling
the trigger. This guarantees the entire stroke is available
for punching and saves power.
1. Refer to the hydraulic punch instruction manual
for proper punch, die, and drawstud selection
and setup.
2. Select the appropriate punch, die, and drawstud for
the desired hole size.
3. Determine and mark the exact location for the hole.
Use a Greenlee Kwik-Stepper
hole slightly larger than the drawstud being used.
4. Depress the Return button to reset the ram to the
starting position.
5. Thread the appropriate drawstud completely into
the ram in the punching head.
6. Slide the corresponding die onto the drawstud.
The open end of the die should face away from the
punching head.
7. Insert the drawstud through the pilot hole in the
material being punched.
8. Thread the punch (cutting edge facing the material)
onto the drawstud until the punch assembly is tight
on the material surface.
Note:
• All of the punch threads must be engaged with
the drawstud threads. If any punch threads are
not engaged, reassemble the setup.
• For SPEED PUNCH
drawstud (cutting edge facing the material) and
secure the SPEED LOCK to the drawstud.
9. Press and hold the trigger to complete the punch
cycle. The LS50L2 driver will automatically stop
when it senses the punch is completely through the
material.
10. Unscrew the punch from the drawstud. Slide the die
Greenlee Tools, Inc.
step bit to drill a pilot
®
, slide the punch onto the
®
LS50L2 Knockout Driver
Release the trigger when the punch completes the
hole. The LS50L2 may not sense when a hole is
made in sheets thinner than 18 ga (1 mm) and soft
materials (such as plastic, etc.).
off the drawstud and remove any slugs from the die.
Note: For SPEED PUNCH
LOCK. Slide the punch off the drawstud; then slide
the die off the drawstud and remove any slugs from
the die
Charging the Battery
Read the instructions supplied with the battery charger.
LED Work Light (white)
This LED automatically turns on when the trigger is
pulled. It remains on for 10 seconds after the trigger is
released.
LED Indicator (red)
This tool is equipped with a special circuit board incor-
porating several important features to inform the user
about the current status of the unit. The LED signals in
the following cases:
What happens
Flashing light for 2 seconds
Constant light for 20 seconds
at end of cycle
Tool will not start, and
constant light for 20 seconds
when trigger is released
Tool will stop, and constant
light for 20 seconds after
trigger is released
Tool will stop, and flashing
light for 20 seconds when
trigger is released
7
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
, remove the SPEED
®
Signal What it means
Battery is inserted in tool
Battery charge is below
17 V at beginning of cycle
Battery charge is below
16 V at beginning of cycle
Battery voltage drops
below 13 V during cycle
Motor current exceeds
20 A during cycle
Circuit has become too hot