Manual Station Operation - Irritrol Rain Dial-R Guide De L'utilisateur

Manual Station Operation

Manual station operation provides manual control at the individual
station level and provides the following four control options:
• Station(s) can be operated for a one-time run duration without
altering the station's set run time in an automatic Program .
• Operation can be limited to only one station running manually
or set to allow three stations to run at the same time .
Note: Refer to "Stack/Overlap Option" on page 26 for additional
information regarding manual operations.
• Works with the Manual Advance feature to move up through the
station sequence .
1 . Place the Function switch in the Run position .
2 . Turn the Dial to the Station Number to be manually operated .
3 . Use the
ranging from 1 minute to 5 .9 hours .
4 . Press the Manual button to start the operation .
5 . If this is the only station to be run manually, skip step 6 and
continue at step 7 below .
6 . To add additional stations to the manual run operation, repeat
steps 2 through 4 as needed, then continue at step 7 .
Note: Depending upon the Stack/Overlap setting, additional
stations selected (beyond the one or three option setting) will
register as OFF when entered with the Manual button. However,
they will be placed (stacked) in the manual sequence to run.
7 . Turn the Dial to the Current Time position .
Note: Once started, the station sequence can be manually
advanced by pressing the Manual button.
Note: To terminate manual watering operations, place the
Function switch momentarily in the OFF or Stop position.
/ buttons to set a manual operation run time
33