ANSMANN ENERGY XC3000 Mode D'emploi page 13

Charging current:
Mono D: 4x 2000mA or 1000mA
Baby C: 4x 2000mA or 1000mA
Mignon AA: 8x 2000mA or 1000mA
Micro AAA: 8x 500mA or 250mA
9V E block: 2x 75mA
Li-Ion/Li-Po: 1x 700mA
FAULT DIAgnOSIS
The charger has no function:
> check if the mains lead of the power supply is correctly
connected to the power outlet and if the output cable
of the power supply is correctly connected to the charger
> check if the outlet has power; connect another
functional electrical device to check the power outlet
The inserted battery is not being charged:
> check if the batteries are inserted with the correct polarity;
cylindrical batteries have to be inserted as per the battery
symbol engraving in the charging slot
> ensure that you inserted suitable rechargeable batteries
into the charging slot; suitable batteries for charging
are only NiCd/NiMH battery types of AAA, AA, C, D, and 9V
block as well as Li-Ion/Li-Po battery packs which can only
be charged by using the provided universal adapter plate
> check for Li-Ion/Li-Po battery packs whether the universal
adapter plate is connected in the right way and whether
the contacts of the adapter plate are in the correct position
to contact the battery pack
> when the display shows the error symbol
(see picture ), the battery is defective or a non
E
rechargeable battery was inserted
Other problems
> please contact us
(address see last page of this operating instructions)
DIScLAIMEr
Information in these operating instructions can be changed
without prior notice. ANSMANN cannot accept liability for
direct, indirect, accidental or other claims or consequential
damages originated by not using this device as indicated by
these operating instructions.
WArrAnTy nOTIcE
We hereby offer a 3 year warranty on this charger. This does
not apply to damage caused by low-quality batteries leaking
inside the charger.
Technical details subject to change without prior notice.
No liability accepted for typographical errors or omissions.
09/2010