Settings Of The Drive Control - Quintezz Drive Control Mode D'emploi

If the Radar / Laser Detector is installed, it will start working immediately. The GPS alarm will only be working after the connection
to the satellites is established.
ATTENTION:
The first time the DRIVE CONTROL is switched ON, it can take about 15 minutes to catch the satellites. Obstacles in the direct
environment and the moving of the car can extend the duration of the first connection to the satellites.
The DRIVE CONTROL will stay connected with 4 to 12 satellites. If the connection is shortly cut (for example when passing through
flyunders and tunnels) the display will go to connection mode, showing
3.3 DRIVING MODE
The DRIVE CONTROL is the perfect solution to prevent you from speeding a few kilometers by accident. When the connection with
the satellites is OK, you will see the following display, showing the time.
When the car is moving, the real speed and heading is shown.

SETTINGS OF THE DRIVE CONTROL

4.1 VOLUME SETTING
You can set the volume by the VOL – or VOL + key.
4.2 SETTING MENU
The menu button is located at the top of the DRIVE CONTROL and indicated with "SETTING". By pressing this button, you will access
the setting menu that contains the following choices:
1. Rlogic: 0 / 1 / 2 / 3 / 4 / CITY (visible when radar is on)
2. X/Ku: ON/OFF
3. K: ON/OFF
4. Ka: ON/OFF
5. Ka N: ON/OFF
6. MAX: Maximum speed for overspeed warning
7. Default / Details / Comfort: The screen information mode
8. Bell: ON / OFF
9. Lang: SP / FR / GB / D / I
-GB-4-