LaTrax TETON 76054-5 Manuel De Demarrage Rapide page 8

TURNING ON YOUR MODEL
1. Turn on the transmitter.
Always turn the transmitter on first, before turning on the model. The transmitter's LED will glow.
2. Plug the battery into the speed control.
Make certain the plugs are fully engaged.
3. Turn on the model.
Press and release the EZ-Set button on the speed control. The LED will glow red.
Note: If the LED is not red, see the Owner's Manual at LaTrax.com for more information, or contact
LaTrax Customer Service at 1-888-TRAXXAS (1-888-872-9927)*.
*Toll-free support is available to U.S. residents only; ouside the U.S., please call +1-972-549-3000.
BEFORE OPERATING YOUR
MODEL
Check servo operation
Confirm the model's wheels turn right and left when
the transmitter steering wheel is turned right and
left. The front wheels should be pointing straight
ahead. If they are turned slightly, slowly adjust the
steering trim knob on the transmitter until they are
pointing straight ahead.
Range test the radio system
With a friend's help, check servo operation at the
farthest distance you plan to drive the model and
confirm that there is no radio interference.
OPERATING YOUR MODEL
Avoid running your model in tall grass, deep sand,
or other conditions that severely limit the driving
performance of the model. This will strain the power
system and could cause early motor failure. If the
model becomes stuck, do not apply throttle.
Free the model before continuing.
The transmitter has a directional antenna.
For maximum range, hold the transmitter upright
and pointed in the direction of the model. Pointing
the transmitter away from the model will reduce
radio range.
AFTER YOU RUN YOUR MODEL
1. Turn the model off.
Press and release the EZ-Set button on the speed control. The speed control's LED will go out.
2. Unplug the battery and remove it from the model.
Do not store the model with the battery installed.
3. Turn the transmitter off.
Always turn the transmitter off last, after the model has been turned off.
8
1
1
2
Set Button
Steering Trim
Forward
Note: After stopping the model,
return the transmitter's trigger
to neutral and push forward to
activate reverse throttle.
2
3
Brake/
Reverse
Neutral
3