Publicité
THE PICTURES AND/OR THE DRAWINGS BELOW INTEND TO MAKE YOU FAMILAR WITH DIFFERENT FUNCTIONS OF
YOUR IMPACT DRILL. THESE PICTURES AND/OR THE DRAWINGS MAY NOT SHOW THE ACTUAL IMPACT DRILL
MODEL THAT YOU HAVE PURCHASED. BEFORE ANY INTERVENTION, YOUR IMPACT DRILL MUST BE UNPLUGED
FROM THE POWER SOURCE.
COUNTER-CLOCKWISE
CLOCKWISE
CHUCK JAW
CHUCK SLEEVE
FIG. 1
SIDE HANDLE
FIG. 2
FIG. 3
HEX KEY
SCREW
FIG. 4
IMPACT DRILL IN OPERATION
ASSEMBLY
1. INSERTING OR REMOVING THE DRILL
PLACE "FORWARD/REVERSE" LEVER ON THE "L" POSITION. GRIP
TIGHTLY THE CHUCK SLEEVE WITH ONE HAND, LOOSEN THE CHUCK
JAWS BY TRIGGERING THE IMPACT DRILL AT LOW SPEED. INSERT THE
DRILL INSIDE THE CHUCK. PLACE "FORWARD/REVERSE" LEVER TO THE
"R" POSITION. GRIP TIGHTLY THE CHUCK SLEEVE WITH ONE HAND,
TIGHTEN THE CHUCK JAWS BY TRIGGERING THE IMPACT DRILL AT
LOW SPEED (FIG. 1).
REVERSE ALL THE OPERATIONS STEP BY STEP MENTIONED IN POINT 1.
TO REMOVE THE DRILL.
2. INSTALLING OR REMOVING THE SIDE HANDLE
THE SIDE HANDLE PROVIDES ADDITIONAL CONTROL AND SUPPORT
FOR THE IMPACT DRILL. THIS HANDLE IS ADJUSTABLE 360
ROTATION AXIS (FIG. 2).
3. INSTALLING THE DEPTH GUIDE
THE DEPTH GUIDE IS CONVENIENT FOR DRILLING HOLES OF
UNIFORM DEPTH. LOOSEN THE SIDE HANDLE AND INSERT THE DEPTH
GUIDE INTO THE HOLE IN THE SIDE HANDLE. ADJUST THE DEPTH
GUIDE TO THE DESIRED DEPTH AND TIGHTEN THE SIDE HANDLE (FIG.
3).
4. REPLACING THE CARBON BRUSHES
TO MAINTAIN THE PEAK EFFICIENCY OF YOUR POWER TOOL MOTOR,
WE RECOMMEND THAT THE CARBON BRUSHES BE EXAMINED EVERY
2-6 MONTHS. AS THE CARBON BRUSHES ARE INTERNAL PARTS OF
YOUR POWER TOOL, THE SERVICE MUST BE PERFORMED BY
QUALITIED PERSONNEL.
15/28
A ROUND ITS
°
Publicité
