Publicité
MAIN SAFETY INSTRUCTIONS FOR POWER TOOLS
WHEN USING A POWER TOOL, THE FOLLOWING BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE TAKEN TO
REDUCE THE RISK OF ELECTRIC SHOCK, OF FIRE AND / OR PERSONAL INJURY. READ AND UNDERSTAND THE
USER'S MANUAL BEFORE OPERATING THE POWER TOOL IS REQUIRED.
BASIC ELECTRICAL SAFETY
DOUBLE
INSULATION.
THIS
INSULATED FROM THE MAIN POWER SUPPLY MAKING
IT UNNECESSARY FOR THIS POWER TOOL TO BE
EARTHED.
OUTLET VOLTAGE AND POWER TOOL VOLTAGE
COMPATIBILITY. MAKE SURE THAT THE OUTLET
VOLTAGE IS WITHIN THE VOLTAGE RANGE OF THE
POWER TOOL.
AVOID ELECTRICAL SHOCK. DO NOT WORK IN WET
AND HUMIDE CONDITIONS WITH A POWER TOOL.
BASIC PERSONAL SAFETY
BE
WATCHFUL.
OPERATING
REQUIRES
ATTENTION,
CONCENTRATION
CONTROL TO AVOID ANY PERSONAL INJURY. THUS,
WHILE USING A POWER TOOL YOU MUST NOT BE
TIRED AND/OR UNDER THE INFLUENCE OF ALCOHOL,
DRUGS OR MEDICATION.
USE
SAFETY
EQUIPMENT.
SAFETY EQUIPMENT SUCH AS GOGGLES, DUST MASK,
NON-SKID
SAFETY
SHOES,
PROTECTION
WHENEVER
APPLICABLE.
DRESS PROPERLY. DO NOT WEAR LOOSE CLOTHING
OR JEWELRY SUCK AS NECKLACE THAT CAN BE
CAUGHT BY THE POWER TOOL MOVING PARTS.
REMOVE ANY ADJUSTING TOOL SUCH AS KEY OR
WRENCH. BEFORE PLUG IN THE POWER TOOL,
REMOVE ANY ADJUSTING TOOL TO AVOID ACCIDENT
CAUSED BY THE ROTATION OF THE ADJUSTING
TOOLS LEFT ATTACHED TO A ROTATION PART.
AVOID ACCIDENTAL START.
TOOL
IS
DOUBLE
SWITCH
PLUGGING IN THE POWER TOOL.
AVOID ELECTRICAL SHOCK. ALWAYS HOLD POWER
TOOL BY INSULATED GRIPPING SURFACES, WHEN
PERFORMING AN OPERATION WHERE THE DRILLING
OR
ELECTRICAL WIRES.
MAINTAIN THE POWER TOOL AND YOUR HAND
CLEAN. KEEP POWER TOOL, NOTABLY THE HANDLE(S)
AND YOUR HANDS CLEAN AND FREE FROM OIL AND
GREASE TO ENSURE BETTER CONTROL OF THE
POWER TOOL IN OPERATION.
A
POWER
TOOL
KEEP CHILDREN AND UNTRAINED PEOPLE AWAY.
AND
POWER TOOL USE AND CARE
DO NOT FORCE THE POWER TOOL. DO NOT USE THE
POWER TOOL IN AN INAPPROPRIATE CONTEXT OR IN
A CONTEXT THE POWER TOOL IS NOT DESIGNED FOR.
USE
APPROPRIATE
EACH POWER TOOL IS DESIGNED FOR SPECIFIC
PERFORMANCE. A POWER TOOL DESIGNED TO BE
OR
HEARING
SERVED AS A DO-IT-YOURSELF TOOL SHOULD NOT
AND
WHEREVER
BE USED BY PROFESSIONALS FOR EXTENDED USES
HAVE THE POWER TOOL REPAIRED BY QUALIFIED
PEOPLE. ANY POWER TOOL THAT CANNOT BE
CONTROLLED WITH THE SWITCH IS DANGEROUS
AND MUST BE REPAIRED BY A QUALIFIED PERSON.
DISCONNECT THE POWER TOOL FROM THE POWER
SOURCE BEFORE ANY INTERVENTION. DISCONNECT
THE PLUG FROM THE POWER SOURCE AND/OR THE
11/28
ENSURE THAT THE
IS
IN
THE
"OFF"
POSITION
CUTTING
TOOLS
MAY
CONTACT
BEFORE
HIDDEN
Publicité
