GYS POT PTI-s7 Mode D'emploi page 47

Specific Installation for C2 and C8 arms
For these arms, the Stretches will also need to be changed. Unscrew the short stretches with a flat
spanner and remove the injector. Centre the injector along the axle of the clamp (Caution: beveled side outside) and insert it manually(1)
Position the long stretches in front and screw it on to the clamp axle (maximum torque 15Nm) (2).
Long Stretches
Short Stretches
Stretches types:
Short: C1, C3, C4, C5, C6, C7, C9, C10
Long: C2, C8
ADJUSTMENT OF C ARMS
GYSPOT PTI S7
- Disconnect the cooling liquid pipes.
- Unscrew screw (2) and loosen the lever (3) on the side of the clamp.
- Remove the clamp arm.
- Lubricate both a new arm and the support with contact grease (ref.050440).
Long Injector
Short Injector
- Position screw (4) to fix the arm on the clamp. Tighten it
in manually - do not overtighten.
- Tighten ring (5) manually, then the tighten (6) using the
Allen key.
EN
47