Well Health WH-OX01 Manuel D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
English
Section 4 Product classification, maintenance and troubleshooting
4.1
Maintenance and Storage
• Replace the batteries timely when low voltage
lamp is on.
• Clean the surface of fingertip oximeter before it is
used to diagnose patients.
• Remove the batteries inside if you will not operate
the Oximeter for a long time.
4.2
Possible problems and effective solutions
Problem
1. Finger is not plugged correctly
Sp02 or PR can
2. Patient's Oxyhemoglobin value is too
not be shown
low to be measured
normally
1. The finger might not be plugged deep
Sp02 or PR
enough
is shown
2. Finger is trembling or the patient is on
unsteady
movement status
1. Inadequate power or power off
The Oximeter
2. Batteries might be installed incorrectly
can not be
3. The Oximeter might be damaged
turned on
Indication
1. The product automatically shuts off
lamps are
when no signal is detected in 16 seconds
suddenly off
2. Inadequate power
Possible reason
EN - 5
• It would be better to store the product in
-10-40 °C (14-104 °F) and humidity is 10%-80%.
• Please follow the law of the local government to
deal with used batteries.
1. Retry by plugging the finger
2. Try more times. If you can make sure there
is no problem in the product, please go to
hospital timely for exact diagnosis
1. Retry by plugging the finger
2. Please remain at rest
1. Please replace the batteries
2. Please reinstall the batteries
3. Please contact with local customer service
centre
1. Normal
2. Replace the batteries
Solution

Publicité

Table des Matières
loading

Produits Connexes pour Well Health WH-OX01

Table des Matières