Symbols And Warnings; Tool Starting; Battery Charging - CAMPAGNOLA SPEEDY Mode D'emploi

3.8

Symbols and warnings

General warning
Compulsory Use & Maintenance
Manual reading
Compulsory head protection
4.1

Tool starting

• Plug the battery (12) into its seat in the shear body.
• Switch the shear on by means of the ON/OFF button (5). When the tool is used for the first time, the LED light indicator
(8) becomes green and the alarm emits just 1 beep.
• Press the trigger two times. The blades will open automatically. In case of failure, the blades will not open. Store the tool
and contact an Authorized Service Point.
• Normal pruning: Press the trigger to close the blades and release it to open them again.
• Blade group closing position: Keep the trigger pressed. 3 long beeps indicate that the shear is in stop position.
• In order to check the shear for proper functioning, before using it, press and release the trigger without carrying out cuts,
to close and open the blades. Repeat the operation more times.
• The shear is fitted with two blade opening modes: 100% and 70%. To switch from one mode to the other, keep the
trigger pressed till the emission of one beep. Release the trigger and work in your usual way.
WARNING!
Do not work on trees or stairs, as it is extremely dangerous.
Before starting to work with the tool, wear suitable protective clothing.
4.2

Battery charging

Connect the battery (12) to the battery charger (13) and the plug of the charger to the socket. Avoid using electrical
extension cables, as they are a source of electrical risks. The battery charger LED light (pictures 1-2) becomes red while
charging. When the battery is charged up, the LED light (pictures 1-2) becomes green.
Page 24
Compulsory adequate clothing
Compulsory hand protection
Compulsory feet protection
Use and maintenance manual – Translation of
original Instruction. : 02 date 12/11/2020