Publicité
Les langues disponibles
Les langues disponibles
2xShileded Twisted Pair
(4-wire CANbus)`
Power (options)
The Navigation box can be powered using the MKCANbus wiring from the compatible
E-Motive display or DCP. To power, connect the wiring loom to the 4-pin connector
into the Navigation box on one end, and into the MKCANbus input on the display or
DCP using the other end. The power voltage can go from 10 to 30 VDC.
PxP Display: E-Motive PxP are powered using either a 24v power supply.
iS2LX & MxP: E-Motive mulltimedia display's are powered using 12v power supply.
DCP: DCP GSM device runs off 12v power supply or requires 240VAC.
Setup
+
Switches 1 and 2 are used for elevator shaft address selection. This allows you to
select the shaft where the device is placed. From 1 to 4*.
+
Switch 3 enables manual initiation of Nav learning mode without a display.
+
Switch 4 controls the MKCANbus termination resistor (makes the device end of line).
*Important - Shaft number must correspond to the other items connected along the MKCANbus
e.g. PSP, PRP, DCP, DAU etc. If incorrect the CANbus will not function correctly.
3
Publicité
