List Of Materials; Parts No Supplied; Ducting Options; Ductless (Recirculating) - Elica EAL330S2 Guide D'utilisation, D'entretien Et D'installation

List of Materials

Removing the packaging.
I CAUTION
Remove carton carefully, Wear gloves to protect against sharp
edges.
Supplied Part
Hood assembly and
LED lamps already installed
4.5 x 13 mm
Tools/Materials required
• Drill with 1 ⁄ " (3.0 cm) drill bit and
1
4
pilot holes
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Caulking gun and weatherproof caulking compound
• Saber or keyhole saw
• Metal snips
• Screwdrivers:
- Phillips
- Flat-blade

Ducting Options

Closely follow the instructions set out in this manual. All responsability, for any eventual inconveniences, damages or fires
caused by not complying with the instructions in this manual, is declined.

Ductless (Recirculating)

NOTE:
In cases where it should not
be possible to discharge
cooking fumes and vapour
to the outside, purchase: The
Recirculating Kit.
Pieces
1
1

Parts no supplied

⁄ " (3.0 mm) drill bit for
1
8
I WARNING
Remove the protective film covering the product before
putting into operation.
Supplied Part
Rectangular transition 3 ⁄ " x 10" (8.3 x 25.4
1
4
cm) with back draft dampers
3.5 x 6.5 mm
Optional accessories and consumable parts
KIT
EAL330S2
Recirculating Kit
Valve (damper) Kit
Grease Filters Kit
Make up Air Kit

Horizontal Discharge

Use a rectangular transition
3 ⁄ " x 10" (8.3 x 25.4 cm) for
1
4
discharge of fumes to the
outside.
Pieces
4
3
# Part
EAL336S2
KIT02178 KIT02179
KIT02723
GF04BE GF04BF
KIT02737B
5