Intended Use; Initial Use - Tetra WP 300 Mode D'emploi

UK
SCOPE OF DELIVERY
Fig. A
1 Pump body
2 Friction bearing, spare part (only for WP 600 / WP 1000)
3 Impeller
4 Pump housing
5 Suction cups (WP 300: 2x, WP 600 and WP 1000: 4x)
6 Flow regulator

INTENDED USE

Only use WP 300 / WP 600 / WP 1000
• for water circulation in aquariums,
• in indoor areas,
• for private use,
• in line with the technical data,
• at water temperatures of +4 °C ... +35 °C.
SET-UP
1. Fig. B: Fix the suction cups to the underside of
the pump body and pump housing.
2. Fig. C: Fix the water pump to the aquarium wall
or bottom beneath the surface of the water with
the suction cups.

INITIAL USE

1. Fig. D: Use the flow regulator to adjust to the
desired water flow.
2. Fig. E: Form a "drip loop" with the mains cable
below the socket. This prevents water from
running along the cable into the socket.
3. To switch ON the water pump: insert the power
supply plug in the socket.
4. To switch OFF the water pump: pull out the plug.
6
WP 300 / WP 600 / WP 1000