Install The Battery Pack; Remove The Battery Pack; Operation; Adjusting The Speed - GreenWorks Pro ZTB432 Manuel D'opérateur

3.3

INSTALL THE BATTERY PACK

WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Open the battery door (11).
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack (12) into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Install the battery key (13).
6. Close the battery door.
3.4

REMOVE THE BATTERY PACK

1. Open the battery door (11).
2. Remove the battery key (13).
3. Push and hold the battery release button (14).
4. Remove the battery pack (12) from the machine.
4

OPERATION

WARNING
Hold the handle tightly when you move the machine.
English
4.1

ADJUSTING THE SPEED

The machine has a two-speed button.
1. Push the high speed icon (17) towards the rabbit to set to
high speed.
2. Push the low speed icon (17) towards the turtle to set to
low speed.
4.2 CHANGE THE DIRECTION
BUTTON
The machine has a two-direction button.
1. Push the forward icon (16) to go forward .
2. Push the backward icon (16) to go backward.
Move backward for short distance.
4.3

START THE MACHINE

1. Set the power switch (15) to ON position.
2. Make sure the speed and direction are set to the desired
setting.
3. Press the safety button (18).
4. Press the throttle (2) down to start the machine.
You can press the throttle (2) again to restart the utility
cart within 30 seconds after you release it.
4.4

STOP THE MACHINE

1. Release the throttle (2).
2. Set the power switch (15) to OFF position.
7
NOTE
NOTE
WARNING
IMPORTANT
EN