Annovi Reverberi AR 3.8 DFL Instructions Pour L'assemblage page 45

Stopping, cleaning and decommissioning
Warning
Follow the instructions regarding stopping, cleaning and decommissioning contained in the manual
of the machine in which the motor pump is integrated.
STOP
Warning
Always make sure that, once stop operations have been performed, no part of the motor pump and of
the machine in which it is integrated is moving and no pipes contain liquid under pressure.
Perform the stop operations contained in the manual of the machine in which the motor pump is inte-
grated; unless otherwise indicated, in relation to the motor pump, remember the following:
a) Reset the delivery pressure as described at point a) of the "opeRatIon" paragraph.
b) Disconnect the power supply.
c) Wait for the motor pump and the machine in which it is integrated to cool down.
Warning
Once the motor pump and the machine in which it is integrated have cooled down, be careful:
- not to leave them unattended in the presence of children, elderly people or disabled persons with-
out supervision;
- to arrange them in a stable position without any risk of falling;
- not to put them in contact or in the immediate vicinity of inflammable materials.
Cleaning and decommissioning
Warning
Read the "Precautions concerning pumped chemical products" paragraph carefully.
• All cleaning jobs must only be performed after carrying out the operations described in the "stop" para-
graph, meaning without any moving parts, no pipe full of liquid under pressure and only after com-
plete cooling.
In particular, always remember to disconnect the power supply.
• Any cleaning jobs must be performed in conditions of total stability.
• To clean, do not use thinners or solvents.
CAUTION
• Before proceeding to clean and decommission the motor pump, remember to run it for a few minutes with
clean water so as to clean the ducts and internal parts and remove the chemical products used.
• Do not leave the motor pump stopped with chemical products inside.
• The motor pump must be protected against freezing.
In very cold environments, to prevent the ice from forming inside, before decommissioning, it is best to
suction a car anti-freeze product and then proceed to fully expel it. If it is not possible to protect the motor
English language
GENERAL INFORMATION - PART ONE
45
1
Use and Installation