Hydraulic Lift - GOLDONI MAXTER Serie Emploi Et Entretien

Independent PTO
This PTO is not dependent on tractor drive speed and can be used when the
tractor is moving or stopped.
The independent PTO is engaged with lever 3, Fig. 1-2
Lever 15, Fig. 1-2 can be used to set two rotating speeds:
Fast: 750 Rpm with engine at 3000 Rpm
Neutral
Slow: 540 Rpm with engine at 3000 Rpm
Moreover, in tractors with double clutch assemblies, engagement is carried out
with knob N° 19 fig.1-RS/R – N° 18 fig.2-SN/A which operates the relative clutch
by means of an electrohydraulic command.
Synchronised PTO
Synchronised with all gears, this PTO is used for drive wheel equipped trailers
The synchronised PTO is engaged with lever 3 Fig.1-2.
Lever 15, Fig. 1-2 can be used to set two rotating speeds:
Fast: Wheel/PTO turn ratio: 1/11.18
Neutral
Slow: Wheel/PTO turn ratio: 1/8.65
WARNING: do not use the synchronized PTO with the fast speeds in machines
with double electrohydraulic clutches.

4.8 HYDRAULIC LIFT

This is a rear 3-point hydraulic lift controlled by a spooling valve.
Use lever 1 Fig. 1-2 to operate the lift
Lever back
Lever forward
Lever in middle position = holds implement at different heights
The tractor is also equipped with a double acting auxiliary spooling valve
controlled by lever 2, Fig. 1-2.
The 3-point hitch must NOT be used to tow implements.
= Lift implement
= Lower implement (floating mode where the ground con
tour has to be followed
73