Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Using 2 or more people, lift oven partially into cabinet cutout.
Use the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when
pushing oven into cabinet. Do not push against outside
edges.
2. Push oven completely into cabinet and center oven into
cabinet cutout.
3. Securely fasten oven to cabinet using the # 8–14 x ³⁄₄" screws
provided. Insert the screws through holes in decorative trim.
Do not overtighten screws.
A
B
A. Decorative trim
B. Insert screw.
Install Oven
4. The bottom vent is taped to the top of the oven chassis
enclosure. See the following instructions to install.
Align mounting hole in bottom vent to holes in the oven
frame.
With one #8–18 x ³⁄₈" screw for each side of the vent,
fasten vent securely to the oven frame.
IMPORTANT: Do not block air intake along bottom of oven.
5. Replace oven racks.
6. Grasp door at each side.
7. Replace oven door by aligning and inserting ends of hinges
into hinge slots in the oven frame.
8. Push hinges in as far as they will go and open the oven door
to the fully open position. You should feel the oven door drop
into place.
9. Move the latches back to the locked position.
10. Check that door is free to open and close. If it is not, repeat
the removal and installation procedures. See "Remove Oven
Door" section.
11. Reconnect power.
12. Display panel will light briefly, and the clock should appear in
the display.
13. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your oven.
7
Publicité
Table des Matières
