Publicité
Les langues disponibles
Les langues disponibles
4. Then unplug the 12V plug from the 12V vehicle
power socket.
5. Cleaning
Water penetrating into the housing can cause a
short circuit.
- Never immerse the heated seat pad in water.
- Ensure that water does not get into the heated
seat pad.
Improper handling of the heated seat pad can
cause damage.
- Do not use abrasive cleaners, brushes with metal
or nylon bristles and sharp or metallic cleaning
objects such as knives, scrapers and the like. This
will damage the surface.
- Never put the heated seat pad in the washing
machine.
1. Before cleaning unplug the 12V plug from the
12V vehicle power socket.
2. Let the heated seat pad cool completely.
3. Wipe the heated seat pad off with a slightly
damp cloth.
4. Allow all parts to dry completely afterwards.
6. Maintenance
Only use replacement fuses with the specified tech-
nical data.
There is a fuse in the 12V plug to protect the elec-
trical system of the vehicle. Check and replace the
fuse when the heated seat pad no longer works
(see Fig. D).
1. Unscrew the screw cap
from the 12V plug
2. Remove the plug tip
3. Remove the fuse
.
9
4. Insert a new glass tube fuse (F5AL250V) onto
the spring
.
8
5. Place the plug tip back on top of the new fuse.
6. Turn the screw cap clockwise to the 12V connector
7. Storage
Risk of short circuit!
Risk of damage!
Risk of fire and injury!
counter clockwise
11
.
7
.
10
- Allow the heated seat pad to cool completely.
- Store the heated seat pad in a clean, dry place.
- Keep the heated seat pad out of reach for child-
ren.
- Avoid that the heated seat pad is kinked during
storage by heavy objects being placed on it.
- Do not weigh down the heated seat pad with
heavy objects.
8. Troubleshooting
For faults not listed here, please contact the manu-
facturer.
Fault
Possible cause Rectification
The 12V connector
The heated
seat pad is
is not plugged into
not functio-
the 12V vehicle
ning.
power connector.
There is no vol-
tage at the 12V
vehicle power
socket.
The
The 12V electri-
ignition is
cal power socket
switched
fitting is dirty. The
on but the
contact is therefo-
heated
re interrupted
seat pad
The fuse of the
does not
12V plug has
work.
blown.
The vehicle fuse
has blown
9. Technical data
Model:
Measurement seat part: ca. 43,5 x 48 cm
Measurement rear part: ca. 54,5 x 48 cm
Measurement total:
External material:
Internal material:
Temperature max.:
Power rating:
Power supply:
Protection class:
Fuse:
This heated seat pad has been tested by TÜV-TÜV Rhein-
land Group (TÜV Kraftfahrt GmbH. Institute for Traffic Sa-
Plug the 12V plug into
the 12V vehicle power
socket correctly.
In many vehicles, the
ignition must be turned
on for the 12V vehicle
power socket to be live.
Clean the 12V vehicle
power socket properly.
Replace the fuse of the
12V plug, see section
Maintenance.
Replace the vehicle fuse
for the 12V vehicle po-
wer connector. Please
refer to the handbook
for your vehicle.
17181 (Clix I)
ca. 98 x 48 cm
Polyester
Polyurethane foam and Polyester
50° C
29,0 W (Low: 24 W,
High: 29 W)
12V
III
(6 x 30) mm, Typ F5AL250V
Publicité
