Fisher & Paykel RF170 Instructions D'installation Et Guide D'utilisation page 15

7. What to do if your product is unstable
Gently push the refrigerator back until the rear rollers
E
contact the floor.
Measure the gap under the front foot, which has come
■ ■
off the floor.
Obtain some solid packing material (hardwood,
■ ■
plastic, etc) which fits firmly into the gap under the foot.
Note: do not use metallic materials that may corrode,
stain and/or damage floor coverings.
Wind both front feet up and roll the product out
F
of position.
Place the packing material in the location diagonally
■ ■
opposite the front roller that lifts off the floor.
Make sure the packing material stays in place when the
■ ■
product is pushed back into position.
Ideally, the packing material is large enough to rest
■ ■
against the back wall so as to prevent it moving when
the cabinet is pushed into position.
Wall behind refrigerator
For example: if this foot lifts off
the floor when pushing gently on
the top front of the refrigerator
Roll the refrigerator back into position and adjust front feet as per step
G
door closing action are satisfactory).
Make small adjustments to front feet where necessary.
■ ■
Check that the product is stable (all 4 feet are on the floor). If not return to step
■ ■
steps and .
F G
Installation instructions
This foot lifts off the floor when
top front is gently pushed back
Fig.13 Unstable refrigerator
Packing material goes under rear roller
diagonally opposite front foot that lifts
Fig.14 Stabilizing your refrigerator
Example only
Un-level floor
. (Check alignment and
D
and repeat
E
US
13
CA