Schumacher RED FUEL SL158 Manuel D'utilisation page 5

5. CHARGING
IMPORTANT! CHARGE THE WORK LIGHT IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE, AND AT LEAST EVERY 6 MONTHS. Failure to do this will
reduce the battery's capacity and may void the warranty.
5.1 Connect the micro USB end of the charging cable to the micro USB port on the
back of the work light.
5.2 Insert the USB end of the cable into the USB port on the wall charger.
5.3 Plug the AC charger into a live AC outlet.
5.4 The charging LED will light RED, to indicate charging has begun.
5.5 When the battery is fully charged, the charging LED will change to GREEN.
5.6 Recharge the work light after use, and at least every 6 months.
6. OPERATING INSTRUCTIONS
6.1 Hang the work light, using the hooks on the back. The work light can be rotated 360°
for more precise positioning. To rotate the end light 90°, first pull downward to open.
6.2 The magnets may be used instead. Attach to any ferrous metal surface.
6.3 Direct the lens away from your eyes before turning on the work light.
6.4 Press once to turn on the 3W end LED.
Press a second time to turn the SMD LEDs on high.
Press a third time to turn the SMD LEDs on low.
Press to turn off.
6.5 Recharge the work light after use, and at least every 6 months.
7. MAINTENANCE INSTRUCTIONS
7.1 After use and before performing maintenance, unplug and disconnect the work light.
7.2 Use a dry cloth to wipe any dirt or oil from the chargers, cords and case.
7.3 Ensure that all of the work light's components are in place and in good working condition.
7.4 Servicing does not require opening the unit, as there are no user-serviceable parts.
7.5 Any servicing should be performed by qualified service personnel.
8. STORAGE INSTRUCTIONS
8.1 Store inside, in a cool, dry place.
8.2 Take care to avoid/prevent damage to the chargers, cords and unit. Failure to do
so could result in personal injury or property damage.
8.3 Charge the work light's internal battery immediately after purchase, after every
use and every 6 months.
• 5 •