Publicité
Les langues disponibles
Les langues disponibles
1English1
Do not run the power tool while carrying it at your side. Accidental contact with
the spinning accessory could snag your clothing, pulling the accessory into your
body.
Regularly clean the power 'tool's air vents. The motor's fan will draw the dust
inside the housing and excessive accumulation of powdered metal may cause
electrical hazards.
Do not operate the power tool near flammable materials. Sparks could ignite
these materials.
Do not use accessories that require liquid coolants. Using water or other liquid
coolants may result in electrocution or shock.
Maintain a firm grip on the power tool and position your body and arm to allow
you to resist kickback forces. Always use auxiliary handie, if provide, for
maximum control over kickback or torque reaction during start-up. The
operator can control torque reactions or kickback, if proper precautions are taken.
Never place your hand near the rotating accessory. Accessory may kickback over
your hand.
Do not position your body in the area where power tool will move if kickback
occurs. Kickback will propel the tool in direction opposite to the wheel's movement
at the point of snagging.
Use special care when working corners, sharp edges etc. Avoid bouncing and
snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag
the rotating accessory and cause loss of control or kickback.
Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades
create frequent kickback and loss of control.
Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
Shock hazard. When sawing into walls, floors or wherever
CAUTION
"live" electrical wires may be encountered, DO NOT TOUCH
ANY METAL PARTS OF THE TOOL! Hold the tool only by the plastic handle and
housing to prevent electric shock if you saw into a "live" wire.
Wear appropriate personal hearing protection during use. Under some conditions
and duration of use, noise from this product may contribute to hearing loss.
When not in use, place tool on its side on a stable surface where it will not cause a
tripping or falling hazard. Some tools with large battery packs will stand upright on
the battery pack but may be easily knocked over.
English
-7
Publicité
