Publicité
Les langues disponibles
Les langues disponibles
1English1
Do not modify the tool, safety devices, or accessories.
Do not use this tool for purposes other than those recommended.
Note the position of the reversing mechanism before operating the tool so as to
be aware of the direction of rotation when operating the throttle.
Exposed throttles shall not be used where obstructions can hold the throttle in
the "on" position.
Periodically check the drive end of the tool to make certain that the socket
retainer functions correctly, and that sockets and drive ends are not excessively
worn which may allow the socket to come off when rotating.
When a secondary handle is supplied, ensure it is properly installed and use two
hands to maintain control when operating tool.
If the tool is to be with a balancer or other suspension devise ensure that the tool
is firmly attached to the suspension/support device.
To turn off the air supply to the tool and press the on/off valve to exhaust the air
from the feed hose before installing, removing or adjusting any accessory on this
tool.
Do not lay down the tool until the working attachment has stopped moving
completely.
The on/off device is designed in side or outside of the grip. It is a "plug-and-run"
type device. This tool will stop operation/rotation in a few seconds after reliving
the level control.
The speed set up device is indicated by an arrow mark and intergraded with an
indication either marked by "H" (high) and "L" (low) or by "+" (high) and "-"
(low), rotating the knob to desired speed.
Anticipate possible reaction force when the drill bit get stuck, which occurs
when breaking through the material being drilled or when the drill is heavily
loaded.
When getting stuck, release the trigger and remove the drill bit from the
workpiece by rotating it in the reverse direction.
Securely tighten drill bits or other accessories in to the chuck before operating
the drill.
When using a chuck key, remove it before starting the drill.
When a supporting handle or other means is provided with a high torque tool it
should be used to minimize the hazard due to the reaction force.
Before operating the instrument, Be sure of all couplings and plugs are tightly
secured.
English
-6
Publicité
