Publicité
Les langues disponibles
Les langues disponibles
2
WRONG
Fig. 2.5a
CORRECT
Fig. 2.5b
12
CHOICE OF BURNER
The symbols printed on the panel above the gas knobs indicate the correspondence
between the knob and the burner.
The most suitable burner is to be chosen according to the diameter and volume capac-
ity of the container to be warmed.
It is important that the diameter of the pots or pans suitably match the heating potential
of the burners in order not to jeopardise the efficiency of the burners, bringing about a
waste of gas fuel.
A small diameter pot or pan placed on a large burner does not necessarily mean that
boiling conditions are reached quicker.
Fig. 2.4
DIAMETERS OF PANS WHICH MAY BE USED ON THE HOB BURNERS
BURNER
Semi-rapid
Triple-ring
Dual
Do not use pans with concave or convex bases (apart from wok pans used with the
special pan-support fitted)
CORRECT USE OF DUAL BURNER
The flat-bottomed pans are to be placed directly onto the pan-support.
When using a WOK you need to place the supplied stand in the burner to avoid any
faulty operation of the dual burner (Figs.-2.5a - 2.5b).
IMPORTANT:
The special grille for wok pans (fig. 2.5b) MUST BE PLACED ONLY over the pan-rest
for the dual burner.
Make sure that the handles of
cookware do not stick out over the
edge of the range, to avoid them
being knocked over by accident.
This also makes it more difficult
for children to reach the cooking
vessels.
(fig. 2.4)
MINIMUM
16 cm (6" 19/64)
26 cm (10" 3/16)
26 cm (10" 3/16)
Wok pans min 36 cm (14" 3/16) - max 40 cm (15" 3/4)
MAXIMUM
24 cm (9" 7/16)
28 cm (11" 1/16)
28 cm (11" 1/16)
(Fig.-2.5a - 2.5b)
Publicité
