Fisher & Paykel DCS CAD1-30 Instructions D'installation Et Guide D'utilisation page 16

INSTALLATION
SINK DRAIN ASSEMBLY INSTRUCTIONS (OPTIONAL)
WARNING!
Beware of pinch points and sharp
edges to avoid injury to arms and
hands.
B. Install the bracket tab on both sides of the ap-
pliance head using 8 of the 10-24 x 1/2" screws.
Install each bracket with 4 screws on each side of
the outdoor appliance head (Fig. 39 and 40).
9. Place head onto cart (2 persons required)
A. Remove drip tray/pan (Fig. 41) and other remov-
able components (to lighten the load) such as
grates, top burner caps and components for
easier handling.
B. Two persons required to lift head. To place the
head on cart, place rear of head over the rear of
the cart first (Fig. 42), then allow the rear side
tabs to first locate in the slots on the top of
the cart sides. The other tabs will locate in the
middle and front slots as the head is lowered into
position on the cart (Fig. 43).
Fig. 42
14
Fig. 39
SCREWS
Fig. 40
Fig. 41
TABS
Fig. 43