Fisher & Paykel DCS CAD1-30 Instructions D'installation Et Guide D'utilisation page 11

INSTALLATION
SIDE SHELF ASSEMBLY INSTRUCTIONS (OPTIONAL)
STEP 6
Optional Attach Side Shelf Accessory on Either Side
NOTE: Side shelf Model CAD1-SK can be installed with the head already on
the cart.
1. Screw shoulder bolts (2) into the bottom screws on the side of the cart
(Fig. 20 and 21). Tighten with 5/32 Allen wrench.
2. Slide left and right side shelf brackets over the shoulder bolt (Fig. 22) and
install top screw attaching the side shelf brackets onto the cart (Fig. 23).
Tighten with Phillips screwdriver.
3. Holding the side shelf, install 2 shoulder bolts into the slot and screw into
side shelf tray (Fig. 24). Tighten with a 3/16 Allen wrench (Fig. 25).
4. Place shelf in the up position and check for lev-
If shelf is not level, adjust side shelf set screw. Set screws can be adjust-
using a 3/32 Allen wrench (Fig. 26). Turn the Allen wrench clockwise to
raise the shelf. Turn 1/4 turn and review to see if the shelf is level. The set
screws in the left and right bracket should be adjusted equally to ensure
the shelf sits level.
Fig. 22
Fig. 25
Fig. 23
9
SHOULDER BOLT
SCREW HOLES
Fig. 20
Fig. 21
Fig. 24
Fig. 26
the
el.
ed