Focal SUB 600 P Manuel D'utilisation page 14

SUB 600 P
U s e r m a n u a l
Please validate your Focal-JMlab warranty,
it is now possible to register your product online: www.focal.com/warranty
Connections
On low-level RCA inputs:
When using a 2-channel amplifier with 'Pre-out' line outputs, Sub 600 P should be connected to the RCA
stereo inputs 'Line inputs Right (R)/Left (L)' (fig. B).
On LFE input:
When a multi-channel audio/video amplifier is used, Sub 600 P's single LFE input should be connected to
the audio/video amplifier's 'subwoofer' output (fig. C).
Power up (fig. A)
- Before powering up, refer to the safety instructions.
- Check the voltage selector
- Connect the subwoofer to the mains.
Home Cinema settings (fig. A)
- Connect the subwoofer to the amplifier using the subwoofer's LFE output
- Move the power switch to 'ENABLE'
- Set the 'CROSSOVER' knob
- Adjust the 'VOLUME' knob
- Next, adjust the volume using your amplifier's settings.
Stereo settings (fig. A)
- Connect the subwoofer to the amplifier using the subwoofer's Left & Right outputs
- Move the power switch to 'ENABLE'
- Set the 'CROSSOVER' knob
- Adjust the 'VOLUME' knob
- Adjust the bass level depending on the other speakers used. This adjustment can be done by using as
varied music programs as possible. The bass should be present without being too heavy.
- Select the phase inverter mode (0° or 180°)
the highest and most balanced bass level.
- Fine tune the cut-off frequency to around 100Hz. The lower this value is set to, the deeper and fuller the
bass will sound. The higher it is, the more forceful the impacts will be. The settings are correct when all
these features are simultaneously achieved.
- Readjust the volume settings as required.
- This procedure should be repeated every time the subwoofer changes location.
'Auto Standby' mode
Automatic timed power on / off. The Sub 600 P has an automatic audio signal detection system. When
the 'Auto Standby' detector is set to 'Enable' mode, the subwoofer will turn on immediately when an
audio signal is detected at the input. In 'Disable' mode, the detector is inactive and the subwoofer remains
permanently switched on.
On the other hand, if no signal is detected coming into the subwoofer after approximately 20 minutes, the
detection system will automatically place the subwoofer in stand-by mode.
In the event of prolonged absence for several days, we recommend turning the power detector to 'Off'.
before connecting the power cable into the mains.
6
.
1
in the LFE position.
3
to halfway.
4
.
1
to the middle position (around 100Hz).
3
to halfway.
4
1
. The correct position is the one that subjectively provides
2
.
5
.
5
14