Fisher & Paykel ActiveSmart RF170 Guide D'utilisation page 18

ActiveSmart™ special features
US
16
CA
Manual ice system – freezer drawer models only
An ice storage bin which sits inside the upper top freezer bin provides storage for and gives you
access to clean, clear ice cubes.
Fig.9 Upper left freezer bin, ice storage bin, ice tray,
lid and scoop in correct position
Information about your manual ice system
To make ice, take the ice tray and lid from on top of the ice storage bin. Remove the lid from the
■ ■
ice tray and fill the tray with water. Place the lid back on the ice tray and carefully position it back
on the ice storage bin.
Once the ice is solid, take the ice tray and lid off the ice storage bin, remove the lid from the tray
■ ■
and twist the ice tray at each end. Turn the ice tray over the ice storage bin to dislodge the cubes
into the bin.
Fill the ice tray with clean water and repeat to fill the ice storage bin.
■ ■
Attached to the ice storage bin is the ice scoop which provides hygienic access to ice.
■ ■
To access ice cubes, take the ice tray and lid from the top of the ice storage bin and place on a
■ ■
flat surface. Take the scoop from the front of the bin, scoop cubes into vessel and then replace
the scoop, tray and lid back to the top of the bin.
For maximum ice storage, level the stored cubes with the ice scoop.
■ ■
If ice is not used often, old cubes will become cloudy, taste stale, will shrink and may stick
■ ■
together. Empty the ice storage bin periodically and wash in lukewarm water. Dry thoroughly
and place back in the correct position.
Ice trays and lid (all other models)
To empty the ice cubes into the lid, hold the tray and lid together and twist to dislodge.
■ ■
Refill the ice tray with water, place lid containing ice cubes on top and store in the freezer.
■ ■
Ice cubes are best stored in a closed container or plastic bag as they readily absorb odors and
■ ■
tastes from other foods.
Fig.10 Accessing your ice