Homak Security HS30103630 Guide D'utilisation Et Directives De Fonctionnement page 3

2. Foam Component
The foam part is shown below. The part has been designed to fi t into
the cabinet. Carefully, remove the paper backing revealing the adhesive
backing and place neatly into the cabinet. Once the backing has been
removed and the foam is attached, it can not be removed without
damage.
Decide the height that you will place the barrel rest. From this measure-
ment cut the back wall foam into two pieces at the height that you will
place the barrel rest. Any extra that is left may be placed above the barrel
rest on the back wall.
B
Foam
C
Components
BARREL REST
MOUNTING BAR
Left Back Wall Right
Side Foam Side
Foam Foam
Bottom
- 3 -