Specifications; Cutout Dimensions - Fisher & Paykel DCS WD1-30-SSOD Guide D'utilisation

INSTALLATION INSTRUCTIONS
PROUD INSTALLATION

SPECIFICATIONS

The cabinet depth from the outer edge of the face frame to the inside back of the cabinet or wall should be at
least 24 3/16" inches (see figure 02A).
The Warming Drawer should be installed into a base cabinet with minimum outside dimensions of 18 1/2" high by
31" wide by 24 3/16" deep (see figures 03A & 04A).
Power supply required: 120 VAC; 15 amp GFI (Ground Fault Interrupt) circuit

CUTOUT DIMENSIONS

2-1/2" min. to
bottom of
countertop
14-11/16"
(372mm)
28 3/8"
(720mm)
30"
Fig. 03A
23 1/4" (590mm)
1 1/8" (28mm)
26 1/8" (663mm)
24 1/8" (613mm)
2-1/2" min. to
bottom of
countertop
14-11/16"
(372mm)
28 3/8"
(720mm)
A 120 Volt AC (GFI)
outlet should be
located below the
Warming Drawer
2x4's or similar
support
24 3/16" (614mm) min. cabinet depth
Fig. 02A
28 3/8"
(720mm)
PROUD
1 7/8" 1 7/8"
1 1/8" (28mm)
(47mm) (47mm)
21 1/8"
Position supporting boards as shown so
(537mm) product can be secured into position.
16"
1"(25mm)
7
Electrical
outlet
11-11/16"
14 -7/16"
(297mm)
(367mm)
A 120 Volt AC (GFI)
outlet should be
located below the
Warming Drawer
2x4's or similar
support
24 3/16" (614mm) min. cabinet depth
28 3/8"
(720mm)
PROUD
1 7/8" 1 7/8"
(47mm) (47mm)
21 1/8"
Position supporting boards as shown so
(537mm) product can be secured into position.
30"
23 1/4" (590mm)
26 1/8" (663mm)
24 1/8" (613mm)
Electrical
outlet
Installed
Drain
bracket
13/16"
(20mm)
12-1/4"
(311mm)
Fig. 04A
16"
11-11/16"
14 -7/16"
(297mm)
(367mm)
1 -5/8"
(41mm)