Connecting The Ipod; And The Usb Device; Connecting An Ipod; Connecting Usb Devices - Yamaha MCS-1330 Mode D'emploi

CONNECTING THE iPod

You can connect various audio components, USB device or iPod to the receiver. For information on your external
component, refer to the owner's manual supplied with each component.

Connecting an iPod™

The receiver is equipped with a terminal on the top panel
where you can station your iPod and control playback of
your iPod using the supplied remote control.
Use this receiver with iPod dock adapter (supplied with
your iPod or commercially available) appropriate for your
iPod. If you use this receiver without using an appropriate
iPod dock adapter, loose connection may result.
y
When the receiver is turned on or in standby mode, connect the
iPod during the playback, the receiver automatically starts
playback of iPod .
ON/STANDBY PHONES
OFF
Notes
• Only iPod (Click and Wheel), iPod nano, and iPod mini, and
iPod touch are supported.
• Do not connect any iPod accessories (such as headphones, a
wired remote control, or an FM transmitter) to your iPod when
it is stationed in a terminal.
• Unless your iPod is firmly stationed in a terminal, audio signals
may not be output properly.
• Once the connection between your iPod and the receiver is
complete and the receiver is set to iPod mode (see page 5),
"CONNECTED" appears in the front panel display. If the
connection between your iPod and the receiver fails, a status
message appears in the front panel display. For a complete list
of connection status message, see the iPod section in
"TROUBLESHOOTING" on page 21.
• When your iPod is stationed in a terminal of the receiver, your
iPod can be charged automatically even when the receiver is in
standby mode.
• You can disconnect the iPod during the playback.
iPod
iPod
VOLUME
INPUT PURE TUNER PRESET
DIRECT
MIN MAX
Receiver
CONNECTING THE iPod
™

AND THE USB DEVICE

Connecting USB devices

This CD player has a USB port and can access MP3 or
WMA files saved on your USB device. Connect your USB
device to the USB port on the front panel of the CD
player.
CAUTION
Do not disconnect your USB device while the USB indicator is
blinking.
ON/STANDBY
OFF
■ Supported USB devices
This CD player supports USB mass storage class devices
(e.g., flash memories, card readers or portable audio
players) using FAT16 or FAT32 format.
Notes
• Some devices may not work properly even if they meet the
requirements.
• Do not connect devices other than the USB mass storage class
devices.
• When you insert two or more memory cards at the same time
using card readers, etc., only one of the memory cards is
recognized.
• Yamaha and suppliers accepts no liability for the loss of data
saved on the USB devices connected to the receiver. As a
precaution, it is recommended that the files are made backup
copies.
• Playability of and power supply to all kind of USB devices are
not guaranteed.
• When your USB device is connected to the USB port, your
USB device can be charged automatically even when the CD
player is in standby mode and ECO mode is OFF (see page 13).
• You can disconnect the USB device during the playback.
™
AND THE USB DEVICE
USB
CD player
USB device
11
En