Led Status; Main Switch - CARVIN SANICLEAR 40 Manuel D'installation Et D'opération

LED Status

- POWER, The salt chlorinator has input power when light is illuminated
- GENERATING: This LED light is on during normal operation cycle. When it is flashing, the pool water is
either too hot or too cold for the system to operate.
- SUPER CHLORINATE: Light is illuminated during the super chlorination mode.
- REMOTE CONTROLLED: The part is controlled by a remote control system.
- NO FLOW: When this light is illuminated, the flow switch has spotted no flow and salt chlorinator is NOT
generating chlorine. A flashing LED light will indicate that the flow is restored, but there will be a 60 second
delay before generation is re-established.
- CHECK THE SALT: When this light is flashing, the salt level is low (below 2500 ppm) and salt chlorinator
is working at low capacity and efficiency. When it illuminates in a steady motion, the salt level is too low and
the salt chlorinator has turned OFF.
VERY IMPORTANT: Seek a professional to test your water for salt level before adding large quantities of salt.
- HIGH SALT: When this light is illuminated, the salt level is too high（above 5000 ppm for model
SANICLEAR 40, above 7000 ppm for model SANICLEAR 40） and salt chlorinator has shut down. The pool
water must be diluted with fresh water before operation is restored.
- INSPECTION OF CELL: If this light is flashing, it is time to inspect the cell or it shows the cell efficiency is
reduced. If either case occurs, inspect the cell and clean if needed. Pressing the "diagnostic" button next to the
display for 3 seconds will stop the flashing LED. When illuminated steady, the cell efficiency is greatly
reduced and the salt chlorinator has stopped producing chlorine. Inspect, clean or replace if necessary.

MAIN SWITCH

- SUPER CHLORINATE: When you need an important water purification, after having many bathers, cloudy
water condition or a heavy rainfall, set the main switch in the SUPER CHLORINATE position. It will shock
the water for a period of 24 hours. The filter pump must be running during this time. At the end of the super
chlorination period, be sure to reset the switch back in the AUTO position.
- AUTO: For normal use, leave the main switch in the AUTO position. In AUTO the salt chlorinator will
generate the required chlorine to the "Desired Level %" setting for the duration of the entire filter and pump
cycle.
- OFF: .The system is shut off and there is no chlorine generation in this position.
IMPORTANT: When serving the unit, the OFF switch is not sufficient. THE POWER MUST BE OFF FROM
THE CIRUIT BREAKER.
M10077A