Table Des Matières; Warranty; Installation; Location - Scotsman TC 180 Manuel D'utilisation

User Manual for Ice
Dispenser model TC
180
TABLE OF CONTENTS
Warranty .................................................... Page 2
Installation..........................................................2
Location..............................................................2
Plumbing ............................................................2
Electrical.............................................................3
Final Check List ..................................................3
Initial Start Up ....................................................3
Sanitising & Cleaning..........................................4
Mechanical Maintenance.....................................4
Failure Analysis ...................................................5

WARRANTY

The Warranty conditions are those supplied by
the official distributor for your area. In case of
parts, only GENUINE service parts may be used.
TO INSTALL THE MACHINE
The TC 180 is designed to be installed on a
counter.
Determine the location from the anticipated use
and any options planned for.
This machine is air cooled and sucks air through
the left side panel and blows air out the rear side
of the top panel. Do not install the machine
where the left side air flow might be blocked.
Installation Limitations
This ice system is designed to be installed
indoors, in a controlled environment:
Air temperature
Water temperature
Water pressure
Voltage
(Compared to the nameplate)
Operating the machine outside of the limitations
is misuse and can void your warranty.
Scotsman Ice
manufactured with the highest regard for safety
and performance.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and design are subject to change
without notice.

LOCATION

After uncrating and inspection, the unit is ready
for installation. It is important that the machine
be installed in a location where is enough space
around it to be accessible for service, and
minimum of 150 mm be allowed at the left and
upper side for air circulation. Try to avoid hot,
dirty and crowded locations.
NOTE. It is imperative to do not place on top of the
machine any sort of goods and leave the upper
lowers open for proper air exhaust.
FOR THE PLUMBER
PLUMBING CONNECTIONS MUST BE CONFORM
TO ALL APPLICABLE CODES
CONNECT TO POTABLE WATER ONLY
The model TC 180 has the possibility to have the
water connections through the bottom base:
2
Min
10°C
5°C
1 bar
-10%
Systems are designed
HAND DISCONNECT
POWER
WATER DRAIN
WATER INLET
Max
40°C
35°C
5 bar
+10%
and
SWITCH
WATER
VALVE