Control Module - TEFAL NutriCook P42207 Guide De L'utilisateur

Control module

• The removeable control module is designed to
make it easier to clean your NutriCook.
• Once you remove the timer, the pan and lid are
dishwasher safe.
• The control module comprises all of the
components needed for your NutriCook to
operate. Once mounted on the lid, your NutriCook
can be used normally.
To remove the control module from the lid:
• Turn the lid over.
• Unscrew the module retaining nut using a coin,
while holding the module in the other hand.
• Turn the lid over and remove the control module.
To fit the control module on the lid:
• Position the crown on the lid, with the vent for the
automatic air ventilation system (B) aligned over
the grey valve.
• Position the module, with the handle down, on the lid.
• Turn the complete assembly over while holding the
module against the lid and tighten down the
retaining nut using a coin.
The crown and control module will only fit one
way.
Never use NutriCook without the crown.
Food placed in the
steaming basket
must not touch the
NutriCook lid.
44
When cooking directly in the cooker:
• Always pour a minimum amount of liquid of at least
250 ml (two glasses) into the NutriCook.
For steaming:
• At least 750 ml of water must be poured in.
• Place your steaming basket filled with food into
the bottom of the cooker.
If your NutriCook was heated without any liquid
inside:
• Have your NutriCook inspected by a TEFAL
Approved Service Centre.
Minimum filling
Fig 3
Fig 5
.
.