Onkyo TX-8220 Mode D'emploi page 6

> Before Start > Part Names


(European models)
Rear Panel
1. GND jack: The ground wire of the turntable is connected.
2. FM 75Ω/AM ANTENNA terminals (North American models): Connect the supplied FM
indoor antenna and AM indoor antenna.
DAB/FM ANTENNA terminal (European models): Connect the supplied FM/DAB
antenna.
3. SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a subwoofer cable.
4. SPEAKERS jacks: Connect speakers with speaker cables. You can connect a set of left
and right speakers to each of the A/B terminals.
5. Power cord
6. AUDIO IN jacks: Input audio signals from an other external device with an analog audio
cable.
7. LINE OUT jacks: Connect a recording device, such as a cassette tape deck. Connect to
6
> Install > Playback
 
  

the AUDIO IN jacks on the recording device using analog audio cable.
8. DIGITAL IN OPTICAL/COAXIAL jacks: Input digital audio signals from an other external
device with a digital optical cable or digital coaxial cable.
Setup | Others
