Adjusting The Sound Quality - Onkyo TX-8220 Mode D'emploi

> Before Start > Part Names

Adjusting the Sound Quality

By pressing BASS, TREBLE, etc. on the
remote controller during play, you can
adjust frequently used settings, such as the
sound quality.
0 BALANCE adjustments can only be
made with BALANCE on the main unit.
a
b
20
> Install > Playback
∫ BASS (a)
Enhance or moderate the bass range of the
speakers.
Select between j7 and i7 in 1 dB
increments. (default value: 0)
0 It cannot be set if the DIRECT mode is
selected.
∫ TREBLE (b)
Enhance or moderate the treble range of
the speakers.
Select between j7 and i7 in 1 dB
increments. (default value: 0)
0 It cannot be set if the DIRECT mode is
selected.
c
∫ DIRECT (c)
Switch to the DIRECT mode which outputs
pure sound as it was intended by
d
bypassing the tone control circuits during
play.
∫ TONE (d)
Switch to the TONE mode which enables
BASS and TREBLE.
∫ BALANCE (main unit only)
Adjust the balance of the sounds output
from the left and right speakers.
Select between Li10 and Ri10 in 1 steps
increments. (default value: 0)
Setup | Others