Installation Preparation; Installation Considerations - Thermador Professional VCIB Serie Manuel D'installation

Installation Preparation

Installation Considerations

The custom insert unit is designed for installation inside a
custom-built hood assembly. It is for ducting to the outside.
It cannot be used in conjunction with a recirculation unit.
Hood installation height above a cooktop, rangetop or
range can vary. To obtain the necessary installation height
above a cooktop, rangetop or range, consult the
appliance's installation manual.
10¼" 10¼" 10¼"
(260) (260) (260)
18" 18" 18"
(457) (457)
* Hood width should be no less
than the width of the cooking
surface.
* 30" (762) min. * 30" (762) min. * 30" (762) min.
40" (1,016) max. 40" (1,016) max. 40" (1,016) max.
to Cooking Surface to Cooking Surface to Cooking Surface
* Follow cooking appliance
manufacturer's recommendations
imeters)
NOTICE:
The hood could incur some damage from heat if a
THERMADOR PROFESSIONAL
is operated with multiple burners at high settings under a
hood that is installed at minimum clearances.
E
Cooking
Surface
Figure 1: Typical Hood Installation
®
series range or rangetop
Hood Width
The hood width should be no less than the width of the
cooking surface. For proper performance, the housing must
cover the entire cooking surface.
Where space is not restricted, a wider hood can be used to
increase capture area.
Distance From Cooking Surface
The installation height ranges from a minimum height of
30'' (762 mm) to a maximum height of 40'' (1,016 mm);
however, it is necessary to follow the cooking appliance
manufacturer's installation instructions for proper hood
height.
Unit Weight
When calculating the load for the housing support system,
be sure to consider the weight of the ventilation unit.
Model
VCIN36JP 60 lb (27.22 kg)
VCIN48JP 73 lb (33.11 kg)
VCIN54JP 82 lb (37.20 kg)
VCIB36JP 96 lb (43.54 kg)
VCIB48JP 111 lb (50.35 kg)
VCIB54JP 122 lb (55.34 kg)
IMPORTANT:
The supplied weights address only the ventilation unit and
blower. Installer must account for weight of any materials
of construction when calculating the total dead weight
load of installation, including but not limited to: wall, tile,
mortar, plaster, brick, finishes, partitions, and other
similarly incorporated architectural and structural items. It
is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
Weight
Table 2: Unit Weight with Blowers
English 5